Loading ...
Loading ...
Loading ...
REVERSING THE DOOR SWING (CONT.)
20
Installation Instructions
TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
Remove the base grille by pulling it straight out.
Using a Torx Driver, move the bottom hinge bracket
from the right side to the left side.
NOTE: If the washer is not on the hinge bracket, check to
see if it is stuck to the bottom of the door.
4
TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove the center hinge bracket by removing the
three Torx screws
NOTE: Keep these screws with the hinge bracket.
They are long screws and will be used when installing
the hinge on the other side.
You will need to remove the color-matched cap from
the screw head before you can remove the screw. Use
the edge of a thin flat blade to gently pry the caps off
the screw heads. (A putty knife works well for this.)
Cover the blade with tape to prevent scratching the
paint.
Remove the mullion cover from the left side using
the thin flat blade. Assemble it to the right side.
Remove the Torx screw from the center left side
of the cabinet. Screw it into the holes on the
right side.
Place the center hinge bracket over the holes at the
center left side of the cabinet. Insert and tighten
the three long screws.
Replace the cap by snapping it over the screw with
your finger.
5
TRANSFER DOOR STOPS
On each door, move the metal door stop from the
right to the left.
Move any screws from the left to the right.
6
Screw Cap
Mullion Cover
Loading ...
Loading ...
Loading ...