Loading ...
Loading ...
Loading ...
en Faults and what to do about them.
24
Information on the display panel
Display Cause/remedy
è is lit up ■ The temperature is too high. Wait until the temperature drops.
■ The water level is too high. It is not possible to add laundry. Close the door
immediately if necessary. Press the A button to continue the program.
è flashes ■ Laundry may be trapped. Open and close the door again and press the A
button.
■ If necessary, push the door closed or remove the trapped laundry and then
push it closed again.
■ If necessary, switch the appliance off and then on again; set a programme and
apply the settings you require; start the programme.
r is lit up ■ Turn on the cold water tap fully.
■ The supply hose is kinked/jammed. Correct the position of the hose.
■ The water pressure is too low. Clean the filter. ~ Page 23
E The childproof lock is activated – deactivate it.
Å is lit up Too much foam has been detected and additional rinse cycles have been acti-
vated. Add less detergent to the next wash cycle with the same load. ~ Page 18
: the "Ready in" time
flashes
Mains voltage is too low.
.the "Ready in" time
flashes
Undervoltage during the wash programme.
The programme duration is extended. ~ Page 20
E:18 ■ The drain pump is blocked. Clean the drain pump. ~ Page 22
■ The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~ Page 22
E:23 There is water in the base trough; the appliance is leaking. Turn off the tap. Call
the after-sales service.
E:32 flashes alternately with End at the end of the programme.
Not a fault – the unbalanced load detection system has interrupted the spin cycle
because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum. Spin the laundry
again if necessary.
Loading ...
Loading ...
Loading ...