Loading ...
Loading ...
Loading ...
6
Thermal motor protection
An internal thermal protector has been
designed into your cleaner to protect it
from overheating.
When the thermal protector activates, the
main vacuum motor will stop operating.
If this happens, proceed as follows:
1. Turn the cleaner OFF and unplug from
electrical outlet.
2. Check the cleaner for the source of
over heating problem (ie. Full dirt cup,
dirty filters or clog).
3. Fix the problem by following the steps
in the Operations or Maintenance and
Care section.
4. When the motor cools for approximately
30 minutes, the thermal protector will reset
and cleaning may continue. If the cleaner
will not turn on or the thermal protector
continues to activate, your cleaner may need
servicing. Call BISSELL Consumer Care or
visit the website.
E
Maintenance
& Care
To maintain maximum performance, perform
these simple maintenance steps.
E1 – Filter assembly, cleaning,
and replacement
1. Remove dirt bin from the base of
the canister.
2. Locate the filter on the back of the dirt
bin and pull the latches to separate the
filter from the bin.
3.
Separate the pleated filter from the foam filter.
4. Clean pleated filter by tapping it lightly
against the trash can.
5. The foam filter can be rinsed under water.
NOTE: Make sure the filter is dry before
replacing.
6. Reassemble the components.
E2 – Post-motor filter cleaning
and replacement
1. Locate the post motor filter on the back
of the canister.
2. Remove the filter by pulling down on the
tab and pulling out.
3. Separate the filter from the door.
4. Tap out the filter or replace if needed.
5. Reassemble the components.
E3 – Hard floor tool cleaning
1. Use a coin or slotted screwdriver to turn
the knob from lock to unlock and remove
the roller brush cover.
2. Remove the brush from the chamber
for cleaning.
3. Replace the brush and secure the cover
making sure to lock it in place.
www.BISSELL.com
To reduce the risk of electric shock, turn power switch
o and disconnect plug from electrical socket
before performing maintenance or care.
Do not operate cleaner with damp or wet filters
or without all filters in place.
This product is intended for household use only and not for
commercial or industrial use. Vacuuming of dust from products
like plaster, concrete or ashes will damage the motor and void
the warranty.
Replacement Parts
These items are available for purchase as accessories for your BISSELL vacuum:
To purchase visit www.BISSELL.com.
pArt # pArt nAme pArt # pArt nAme
160-2330 Handle Assembly
160-2084 Pre-Motor Filter / Pleated Filter
160-2085 Pre-Motor Filter / Foam Filter 160-2094 Post-Motor Filter
160-2086 Post-Motor Filter / Unwoven Cloth 160-2088 Dirt Tank
Loading ...
Loading ...