Loading ...
Loading ...
Loading ...
PRODUCT DATA SHEETS
Base Grille Water Filtration System
Model WF-LC200V Capacity 200 Gallons (757 Liters)
Model WF-NLC120V Capacity 120 Gallons (454 Liters)
System tested and certified by NSF International against NSF/ANSI
Standard 53 for the reduction of Lead, Mercury, Benzene,
p-dichlorobenzene, Cysts, Turbidity, Asbestos, Endrin,
O-Dichlorobenzene, Toxaphene, Ethyl Benzene, 1,2,4-trichlorobenzene
and against NSF/ANSI Standard 42 for the reduction of Chlorine Taste
and Odor and Particulate Class I=
This system has been tested according to ANSI/NSF 42/53 for the reduction of the substances listed below. The concentration of
the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for
water leaving the system, as specified in ANSI/NSF 42/53.
Substance Reduction NSF Reduction Average Influent Challenge Maximum Average Minimum % Average %
Aesthetic Effects Requirements Influent Concentration Effluent Effluent Reduction Reduction
Chlorine Taste/Odor _>50% 1.9 mg/L 2.0 mg/L _+10% | 0.12 mg/L 0.08 mg/L >75% >75%
50,000/mL** 99.0% 99.7%
Particulate Class I* _85% 5,300,000/mL At east 10,000 part c es/m 4 15,725/mL
Contaminant NSF Reduction Average Influent Challenge Maximum Average Minimum % Average %
Reduction Requirements Influent Concentration Effluent Effluent Reduction Reduction
Lead: @ pH 6.5 0.01mg/L 0.14 mg/L _ 0.15 mg/L _+10% 0.001 mg/L 0.001 mg/L 99.29% 99.29%
Lead: @ pH 8.5 0.01mg/L 0.15 mg/L t 0.15 mg/L _+10% 0.001 mg/L 0.001 mg/L 99.32% 99.32%
Mercury: @ pH 6.5 0.002 mg/L 0.0058 mg/L 0.006 mg/L _+10% 0.0005 mg/L 0.0003 mg/L 91.37% 94.82%
Mercury: @ pH 8.5 0.002 mg/L 0.0055 mg/L 0.006 mg/L _+10% 0.0013 mg/L 0.0005 mg/L 76.36% 90.90%
Benzene 0.005 mg/L 0.0153 mg/L 0.015 mg/L _+ 10% 0.0036 mg/L 0.0014 mg/L 76.47% 90.84%
p-dichlorobenzene 0.075 mg/L 0.215 mg/L 0.225 mg/L _+ 10% 0.0037 mg/L 0.0010 mg/L 98.27% 99.52%
Asbestos 99.0% 842 x 107 1OTto108fibers/L tt 1.6 x 107 mg/L 1.6 x 107mg/L 99.81 99.81%
Cysts _ 99.95% 165,500/mL 50,000/L min. 1 mg/L 1 mg/L 99.99% 99.99%
Turbidity 0.5 NTU 11.75 NTU 11 _+1 NTU 0.38 NTU 0.22 NTU 96.76% 98.12%
Endrin 0.002 0.0056 0.006 _+10% 0.0007 0.0004 87.50 92.85
O-Dichlorobenzene 0.60 1.84 1.8 _+10% 0.33 0.071 82.06 96.14
Toxaphene 0.003 0.0143 0.015 _+10% 0.001 0.001 93.00 93.00
Ethyl Benzene 0.70 2.00 2.1 _+10% 0.60 0.169 70.00 91.55
1,2,4- trichlorobenzene 0.07 0.232 0.21 _+10% 0.0025 0.0007 98.92 99.69
Test Parameters: pH = 7.5 + 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 63°F (17.2°C).
• It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
• Model WF-LC200V: The filter monitor system measures the
amount of water that passes through the filter and alerts you to
replace the filter. When 90% of the filter's rated life is used, the
filter indicator light changes from green to yellow. When 100% of
the filter's rated life is used, the filter indicator light changes from
yellow to red, and it is recommended that you replace the filter.
Use replacement cartridge LC200V/NLC120V, part #9915. 2004
suggested retail price of $32.99 U.S.A./S49.99 Canada. Prices
are subject to change without notice.
Model WF-NLC120V: Change the water filter cartridge every
6-9 months. Use replacement cartridge LC200V/NLC120V, part
#9915. 2004 suggested retail price of $32.99 U.S.A./S49.99
Canada. Prices are subject to change without notice.
• The product is for cold water use only.
• Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the
system. Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
• Refer to the front cover or "Accessories" section for the
Manufacturer's name, address and telephone number.
• Refer to the "Warranty" section for the Manufacturer's limited
warranty.
A_ cat on Gu de nes_ater Su_ y Parameters
Water Supply City or Well
Water Pressure 30 - 120 psi (207 - 827 kPa)
Water Temperature 33 ° - 100°F (0,6 ° - 37.8°C)
Service Flow Rate 0.5 GPM (1.89 L/min.) @ 60 psi.
*Class I particle size: >0.5 to <1 um
**Test requirement is at least 100,000 particles/mL of AC Fine Test Dust.
tThese contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
ttFibers greater than 10 um in length
_Based on the use of Cryptosporidium parvum oocysts
® NSF is a registered trademark of NSF International.
24
Loading ...
Loading ...
Loading ...