Loading ...
Loading ...
Loading ...
5
2. You can dispense water by the ounce, cup, or liter. The default unit
is ounces. To switch to cups or liters, press the LIGHT button.
Default, minimum, and maximum volumes are listed below.
3. Press the LOCK and OPTIONS buttons to adjust the volume as
desired. The LOCK button increases the volume, and the
OPTIONS button lowers the volume.
NOTES:
When increasing or decreasing the volume, the control may
stop responding if an adjustment button is held for
approximately 10 seconds or longer. Release the button
forapproximately 2 seconds, and then continue making
adjustments.
Most coffee cups (commonly 4 to 6 oz [118 to 177 mL]
per cup) are not the same size as a measuring cup (8 oz
[237 mL]). You may need to adjust the volume to avoid
unintentionally overfilling coffee cups.
4. To dispense water, press a sturdy glass against the water
dispenser pad OR place the glass below the water dispenser and
press the MEASURED FILL button. Hold the glass close to the
water dispenser spout to ensure that the water dispenses into the
glass.
NOTE: While dispensing water, the digital display will count down
how much water remains to be dispensed, according t
o the volume
you selected. The flow of water will automatically stop once the
desired volume has been dispensed.
5. To stop dispensing before the selected volume has been
dispensed, remove the glass from the dispenser pad OR press the
MEASURED FILL button a second time.
NOTE: If you stop dispensing before the desired volume has been
dispensed, the digital display will continue to show how much water
remains to be dispensed. The display will turn off after 1 minute of
inactivity.
To select a new volume or start dispensing the same volume
again,
you must first finish dispensing the selected volume, or turn off the
Measured Fill feature (either by waiting 1 minute so it will
automatically turn off or by pressing ICE TYPE to manually turn it
off) and then turn it back on.
The Ice Dispenser
Ice dispenses from the ice maker storage bin in the freezer when the
dispenser pad is pressed. To turn off the ice maker, see “Ice Maker and
Storage Bin.”
Your ice maker can produce both crushed and cubed ice. Before
dispensing ice, select which type of ice you prefer by pressing the ICE
TYPE button.
The display screen indicates
which type of ice is selected.
For crushed ice, cubes are
crushed before being dispensed.
This may cause a slight delay
when dispensing crushed ice.
Noise from the ice crush
er is
normal, and pieces of ice may
vary in size. When changing from
crushed to cubed, a few ounces of crushed ice will be dispensed along
with the first cubes.
To Dispense Ice:
1. Make sure the desired type of ice is selected. To switch between
cubed and crushed, press ICE TYPE.
2. Press a sturdy glass against the ice dispenser pad. Hold the glass
close to the ice guide to ensure that the ice dispenses into the
glass.
IMPORTANT: You do not need to apply a lot of pressure to the pad
in order to activate the ice dispenser. Pressing hard will not m
ake
the ice dispense faster or in greater quantities.
3. Remove the glass to stop dispensing.
NOTE: Ice may continue to dispense for several seconds after
removing the glass from the pad. The dispenser may continue to
make noise for a few seconds after dispensing.
Units Default Minimum Maximum
Ounces 8 1 128
Cups 1 ¹/₄ 16
Liters 0.25 0.05 4.00
A. Water dispenser spout
A
A. Ice guide
CRUSHED CUBED
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
WARNING
A
Loading ...
Loading ...
Loading ...