Loading ...
Loading ...
Loading ...
Helpful Tip:
o Seiect the proper size twist-on
connectors to connect your househoH _.--4_
wiring to 16°gauge dishwasher w,Mng,
o Insert wire ends into twistoon
connector, Do not preotwist bare wire,
_Twist connector,
®Gendy tug on wires to be sure both
are secured,
3. Connect the wires as follows using twistoon connectors
sized to connect direct wire to 16-gauge dishwasher
wire:
Powersupply wire: Terminal box wire:
white--white
Nack_Nack
ground wire_,_gr0und connector
Electdcam Shock Hazard
EmectricaHy ground dishwasher.
Connect ground wire to green ground connector in
terminam box.
Do not use an extension cord,
Failure to folmow these instructions can resumt in death,
fire, or electricaB shock.
4. Form bare ground wire into a U-shaped hook, Wrap
ground wire hook clockwise around ground connector
and under the washer,
5. Securely tighten ground connector, Do not untie knot in
the wires,
ground wire washer
ground
connector
ground wire
6. Tighten clamp connector or
conduit connector screws,
screws
Reinstall terminal box cover with
wires inside terminal box,
The cover must be outside the box
on the left side,
8. Make sure no wires are pinched by cover,
Option 2, Power suppJy cord method
Emectrical Shock Hazard
Plug into a grounded 3 prong outmet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Faimure to follow these instructions can result in death,
fire, or emectrica_ shock.
1. Plug into a grounded 3 prong outlet,
2. Check that power supply cord does not touch
dishwasher motor or lower part of dishwasher tub,
Connect to water suppJy
He_pfu_ Tip:
Compression fittings:
a, Slide nut onto copper tubing about 1" (2,5 cm),
b, Slide ferrule onto the tubing, Do not position ferrule
on the end of the tubing,
c, Put the tubing into the elbow as far as it will go,
d, Slide the nut and ferrule forward and start the nut
onto the elbow threads, Be gentle when handling
and positioning the copper tubing, it bends and kinks
easily,
elbow
nut
1. To prevent vibration during operation, route the water
supply line so that it does not touch the dishwasher
base, frame or motor,
2. With copper tubing pushed into compression fitting as
far as it will go, use a wrench and tighten compression
fitting nut to elbow on water inlet valve, Do not use
Teflon :_tape with compression fittings,
3. Place paper towel under elbow, Turn on water supply
and check for leaks,
12
Loading ...
Loading ...
Loading ...