Loading ...
Loading ...
Loading ...
Problem Possible cause Remedy
and a number come on.
There is an error in the
hob.
Deactivate the hob and ac‐
tivate it again after 30 sec‐
onds. If comes on
again, disconnect the hob
from the electrical supply.
After 30 seconds, connect
the hob again. If the prob‐
lem continues, speak to an
Authorised Service Centre.
You can hear a constant
beep noise.
The electrical connection is
incorrect.
Disconnect the hob from
the electrical supply. Ask a
qualified electrician to
check the installation.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
8. INSTALLATION
WARNING!
Refer to Safety chapters.
8.1 Before the installation
Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................
8.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.
8.3 Connection cable
• For a single phase or two phase
connection, use the cable type:
H05BB-F or H03V2V2-F which
withstands a temperature of 70°C or
higher.
• To replace the damaged mains cable,
use the cable: H05BB-F or H03V2V2-
F which withstands a temperature of
70°C or higher.
8.4 Assembly
min.
50mm
min.
500mm
ENGLISH 17
Loading ...
Loading ...
Loading ...