Loading ...
Loading ...
Loading ...
22
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE WHAT TO DO
Dishwasher
will not start.
No power. Ensure the dishwasher is plugged in and
the power supply is turned on at the wall.
The door is not properly
closed.
Close the door.
Start/Pause button has
not been pressed.
Press the Start/Pause button
.
Water tap not turned on. Ensure water is connected and turned on.
Blocked strainer in water
inlet hose.
Check the strainer and clean if
necessary—it is located where the water
inlet hose screws into the tap.
Keylock is activated. Cancel Keylock by pressing and holding
and (C1, C2 & C4 models) or
and (C6 models) together for 4
seconds until the keylock indicator goes
out.
Lower
spray arm
rotates with
difficulty.
Spray arm holes are
blocked by small items or
food particles.
Clean the spray arm. See ‘Care
and cleaning’ for instructions.
Cover of
detergent
dispenser
cannot be
closed.
Detergent compartment
has been overfilled.
Remove detergent until the cover can be
closed.
Detergent dispenser is
clogged with remnants of
detergent.
Wipe dispenser out with a damp
cloth. Dry the dispenser before adding
detergent.
Remnants
of detergent
stuck inside
dispenser.
Compartment was damp
when filled with detergent.
Wipe dispenser out with a damp
cloth. Dry the dispenser before adding
detergent.
Buttons beep
and do not
respond.
Keylock is activated. Cancel Keylock by pressing and holding
and (C1, C2 & C4 models) or
and (C6 models) together for 4
seconds until the keylock indicator goes
out.
Water
remains
inside
dishwasher
after wash
has
ended.
Drain hose is crimped, bent,
or blocked.
Check the drain hose and straighten if
needed.
Pump is jammed. Call your Fisher & Paykel Authorised
Service Centre or Customer Care.
Filter(s) blocked. Clean the filter(s). See ‘Care and cleaning’
for instructions.
Foaming. Incorrect amount or type of
detergent used.
See section ‘Adding detergent’ or consult
the detergent manufacturer’s instructions.
Too much egg in the wash
load.
Increase the amount of detergent.
Rinse aid dosage level too
high.
Decrease the rinse aid dosage.
Rinse aid spills not wiped
up.
Ensure that all rinse aid spills are wiped
up when they occur.
Loading ...
Loading ...
Loading ...