Loading ...
Loading ...
Loading ...
14
Refrigerator Leveling &
Door Adjustment
(If needed)
The refrigerator must be level in order to maintain optimal
performance and desirable front appearance.
(If the floor beneath the refrigerator is uneven, the freezer
and refrigerator doors look unbalanced.)
In case freezer door is lower than
refrigerator door...
Insert a screw driver (flat
tip) into a groove of the left
wheel (bottom of freezer)
and turn it clockwise until the
door is balanced. (Clockwise
to raise freezer door,
counterclockwise to lower.)
※ If the freezer door is not balanced by step 1, then
follow the next steps.
Open the doors, unscrew the
front cover and remove, if it is
attached.
Insert a spanner (A part) into the hinge nut (1 part) and
unscrew the nut by turning clockwise.
Insert a spanner (B part) into the hinge nut (2 part)
and turn clockwise to lower the door.
If the door is aligned, fasten the nut (1) tightly by turning
counter-clockwise.
In case refrigerator door is lower than
freezer door...
Insert a screw driver (flat tip)
into a groove of the right wheel
(bottom of refrigerator) and
turn it clockwise until the door
is balanced. (Clockwise to
raise refrigerator door,
counterclockwise to lower.)
※ If the refrigerator door is not balanced by step 1, then
follow the next steps.
Insert a spanner (A part) into the hinge nut (1 part) and
unscrew the nut by turning clockwise.
Insert a spanner (B part) into the hinge nut (2 part) and
turn counter-clockwise to tighten the door.
If the door is aligned, fasten the nut (1) tightly by
turning.
Front Cover
After installation and/or door leveling, fasten front cover with
screws. (Remove the screws on the front bottom panel first.
Click and screw the cover.)
Caution
●The front of refrigerator needs to be just a little
higher than the back for easy door closing, but if
the wheel is raised too much for door balance,
i.e. the front of refrigerator is much higher than
the back, it can be difficult to open the door.
Water filter
1. Remove the locking cap for
intalling the filter.
(The ice and water dispenser can
also be used without a water filter,
in which case the locking cap
must be used. )
2. Carefully turn the filter clockwise.
3. Change the filter at least every
6months.
※ A New filter can be obtained from
aftersales service.
Caution
●Wipe up with cloth if droplets fall when
exchanging a filter.
1
1
2
3
2
4
3
4
5
ZY600-2(영).indd 14 2018-11-19 오후 2:51:53
Loading ...