Loading ...
Loading ...
Loading ...
23
PERFORMANCE DATA SHEETS
Base Grille Water Filtration System
Model WF-NL300/NL300 capacity 300 Gallons (1136 Liters)
Model WF-L500/L500 capacity 500 Gallons (1893 Liters)
This system has been tested according to ANSI/NSF 42/53 for the reduction of the substances listed below. The concentration of
the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for
water leaving the system, as specified in ANSI/NSF 42/53.
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psi (413.7 kPa). Temp. = 63°F
(17.2°C).
■
It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
■
Using Replacement Cartridge NL300 - Model WF-NL300:
The concentration of the indicated substances in water
entering the system was reduced to a concentration less than
or equal to the permissible limit for water leaving the system
as specified in ANSI/NSF 42 and 53. Change cartridge at
least every 6-9 months. Use replacement cartridge NL 300,
part# 4392857. 2002 suggested retail price of $29.95 U.S.A./
$39.95 Canada. Prices are subject to change without notice.
■
Using Replacement Cartridge L500 - Model WF-L500
:
The concentration of the indicated substances in water
entering the system was reduced to a concentration less than
or equal to the permissible limit for water leaving the system
as specified in ANSI/NSF 42 and 53. The filter monitor system
measures the amount of water that passes through the filter
and alerts you to replace the filter. When 90% of the filter’s
rated life is used, the filter indicator light changes from green
to yellow. When 100% of the filter’s rated life is used, the filter
indicator light changes from yellow to red, and it is
recommended that you replace the filter. Use replacement
cartridge L500, part# 4392857. 2002 suggested retail price of
$29.95 U.S.A./$39.95 Canada. Prices are subject to change
without notice.
■
The product is for cold water use only.
■
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system.
■
Refer to the “Assistance or Service” section for parts and
service availability or for the Manufacturer’s name, address
and telephone number.
■
Refer to the “Warranty” section for the Manufacturer’s limited
warranty.
■
Note that while the testing was performed under standard
laboratory conditions, actual performance may vary. Systems
must be installed and operated in accordance with
manufacturer’s recommended procedures and guidelines.
System tested and certified by NSF International against ANSI/NSF
Standard 53 for the reduction of Lead; and against Standard
ANSI/NSF 42 for the reduction of Taste and Odor, Chlorine Class I.
Contaminant
Reduction
Average
Influent
mg/L
Influent Challenge
Concentration
Product
Water
mg/L
Average %
Reduction
Max. Permissible
Concentration
mg/L
Max.
Effluent
mg/L
Min. %
Reduction
Lead: @ pH 6.5
Lead: @ pH 8.5
0.16
0.17
0.15 mg/L ± 10%
0.15 mg/L ± 10%
0.0024
0.0045
98.4
97.4
0.01
0.01
.005
.009
97
95
Substance Reduction Min. Required %
reduction
Chlorine, Taste/Odor 2.0 2.0 mg/L ± 10% 0.14 93.0
≥
75% N/A N/A
Application Guidelines/Water Supply Parameters
Water Pressure
Water Temperature
Rated Service Flow
30 - 120 psi (207 - 827 kPa)
33° - 100°F (0.6° - 37.8° C)
0.5 gpm (1.9 Lpm)
® NSF is a registered trademark of NSF International.
Loading ...
Loading ...
Loading ...