Loading ...
Loading ...
Loading ...
EN4
1. Remove the terminal cover (A) by unscrewing the screw and insert the cover into the hinge (B) of the terminal.
2. Plug the power cord into the clamp and connect the wires to the terminal block as shown in the wiring diagram located near the terminal.
3. Secure the power cable with the cable clamp.
4. Close the cover (C) and screw on the terminal with the screw removed.
For each connection to the network, the hob automatically checks for a few seconds.
ELECTRICAL CONNECTION
WARNING
- Disconnect the appliance from the power supply.
- Installation must be carried out by qualified personnel who know the current safety and
installation regulations.
- The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the regulations
provided in this chapter.
- The power cable must be long enough to allow the hob to be removed from the worktop.
- Make sure the voltage specified on the dataplate located on the bottom of the appliance is the same as that of the home.
blue/grey
black/brown
yellow/green
Connection to main power
ONLY FOR BELGIUM
230V 2 phase 2N
}
black
brown
blue
blue (grey)
yellow/green
}
}
black
brown
yellow/green
blue
blue (grey)
}
black
brown
blue
blue (grey)
yellow/green
black
brown
yellow/green
blue
blue (grey)
ONLY FOR NL
AU and UK
Loading ...
Loading ...
Loading ...