Loading ...
Loading ...
Loading ...
8 9
GETTING READY
1. Charge it first: Before you start using
your new Polaroid Mint printer, plug it
into your computer or any USB charging
block with an output of one amp (1A) or
higher. The charging indicator will stay
red while the printer charges. Once it
turns green, it’s fully charged and ready
to use. The full charging process usually
takes approximately two (2) hours.
2. Load your ZINK
®
paper into the printer:
Follow the steps below to quickly and
easily get your new printer loaded with
ZINK
®
sticky-back paper so you can start
printing photos!
a. Open the paper tray in the back by
pressing down on the latch and
pulling it toward you.
b. Load the blue calibration sheet in
with the barcode facing down and the
ZINK
®
logo in the bottom right corner.
Place the other plain sheets on top
with the glossy side facing you.
Try to avoid touching the glossy side
so you don’t get fingerprints on it.
(You can load the whole stack as-is
from the packet, but sometimes it’s
easier to load the calibration sheet
first to make sure it’s seated correctly
in the tray.)
c. If the printer is off, the calibration
sheet will be slowly ejected from the
photo slot after a few seconds once
you turn the printer on. If the printer
Loading ...
Loading ...
Loading ...