Loading ...
Loading ...
3
You will need:
A water heater set to 120° F (49° C). ■
A grounded electrical outlet located within 4 ft. (0.9 m) ■
of power cord on back of washer.
Hot and cold water faucets located within 3 ft. (0.9 m) ■
of hot and cold water ll valves on washer, and water
pressure of 5-100 psi (34.5-690 kPa).
A level oor with maximum slope of 1" (25 mm) under entire ■
washer. Installing on carpet is not recommended.
Floor must support washer’s total weight (with water ■
and load) of 315 lbs (143 kgs).
IMPORTANT: Do not install, store, or operate washer where
it will be exposed to weather or in temperatures below 32° F
(0° C). Water remaining in washer after use may cause
damage in low temperatures. See “Washer Care” in your
“Use and Care Guide”. Proper installation is your responsibility.
Recessed area or closet installation
Dimensions show recommended spacing allowed, except for
closet door ventilation openings which are minimum required.
Consider allowing more space for ease of installation and
servicing, spacing for companion appliances and clearances
for walls, doors, and oor moldings. Add spacing of 1" (25 mm)
on all sides of washer to reduce noise transfer. If a closet door
or louvered door is installed, top and bottom air openings in
door are required.
3"
(76 mm)
3"
(76 mm)
24 in.
2
(155 cm
2
)
48 in.
2
(310 cm
2
)
19"
(483 mm)
1"
(25 mm)
0"
(0 mm)
4"
(102 mm)
14" max.
(356 mm)
DRAIN SYSTEM
Drain system can be installed using a oor drain, wall standpipe,
oor standpipe, or laundry tub. Select method you need.
IMPORTANT: To avoid siphoning, no more than 4.5" (113 mm)
of drain hose should be inside standpipe or below the top of
wash tub. Secure drain hose with removable tie strap (A).
Minimum diameter for a standpipe drain: 2" (51 mm).
Minimum carry-away capacity: 17 gal. (64 L) per minute.
Some standpipes may require a Standpipe Adapter Kit and
additional drain hose that may be purchased separately. See
“Tools and Parts”. Top of standpipe must be at least 39" (991 mm)
high; install no higher than 96" (2.4 m) from bottom of washer.
Installations higher than 96" (2.4 m) require a sump pump system.
Wall standpipe drain system
Laundry tub drain system
Minimum capacity: 20 gal. (76 L). Top of laundry tub must
be at least 39" (991 mm) above oor; install no higher than
96" (2.4 m) from bottom of washer.
Floor drain system
Floor drain system requires a Siphon Break Kit and additional
drain hose that may be purchased separately. See “Tools and
Parts”. Minimum siphon break: 28" (711 mm) from bottom of
washer. (Additional hoses might be needed.)
Floor standpipe drain system
See requirements for oor standpipe drain system.
4.5"
(113 mm)
39"
(991 mm)
4.5"
(113 mm)
39"
(991 mm)
4.5"
(113 mm)
A
A
A
Loading ...
Loading ...
Loading ...