Loading ...
Loading ...
Loading ...
11
Door Removal Instructions
2 Disconnect the harness by grasping
both sides of the connector rmly,
depress the latch, and pull apart.
Remove the two screws from the top
hinge. Lift the door o of the bottom
hinge and set it aside.
3 Detach the water tube from the
connector located behind the refrigerator
and pull the tube back out to the front
of the unit. The connector releases when
you press inward on the outer sleeve while
pushing the tube toward the connector
then while continuing to hold in the sleeve,
pull the tube away.
Getting through narrow spaces
If your refrigerator will not t through an
entrance area, you can remove the doors.
Check rst by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord
is unplugged from the wall outlet.
2 Open the freezer drawer and remove
the toe grille (see Installation section).
3 Remove any food from the door
shelves and close the doors.
To remove the top hinge covers:
1 Remove the two screws from each
cover over the top door hinges.
2 Lift inside edge of hinge cover and
tilt back.
Rear
Cover
Screw
Ground
Screw
Top
Hinge
Top Hinge
Cover
Hinge
Screws
Multi-wire
Cables
Leave
Hinge
With
Door
Front
Cover Screw
Water
Line
Rear
Cover
Screw
Top
Hinge
Ground
Screw
Front
Cover Screw
Top Hinge
Cover
Hinge
Screws
Leave
Hinge
With
Door
To remove the refrigerator doors
1 Trace lightly around the door’s top
hinges with a pencil. This makes
reinstallation easier.
Press
Press
Approximately
5 feet
Water
Line
NOTE
DO NOT remove the ground screw from
hinge.
NOTE
Use care while pulling the water tube
from the unit to be sure that you do not
kink the tube.
Loading ...
Loading ...
Loading ...