Loading ...
Loading ...
Loading ...
20
thumb pressed here
thumb pressed here
How to remove and install the
Warning:Before remove and install the ,be sure to unplug the
appliance from the power supply.
1 hands with oil blockage ,pressed on the arrow
shown,pushed back slamly,then pulling down.
1.Hands to take the oil blockage,,after
alignment three cylinder of the oil blockage,
inserting the three holes of the back plate.
2.status of remove
2.The left hand grasp the microwave, right thumb to
press the arrow directions and forced to push back.
And the leftthumbhardpressed upwordatthe
sametime. put the right of oil blockage into
the buckle of the feont plate.
3.taking oil blockage from the appliance.
3.From right to left, make the oil blockage loaded.
When finish, check to ensure that the oil blockage
buckle completely go.
ceiling plate
ceiling plate
Splash shield cleaning
1. Detaching: Hold the two front of the splash shield with your
hands (as shown by the arrows). following the direction of
the arrows and pull downwards after you have pulled out the s:
2. Wash the splash shield:
3. Installation: Pick up the splash shield and obliquely put it into the chamber at a
slight angle in
the way that insert the first pin at the rear into the positioning hole
on the rear
plate of chamber, then push the other side to insert all positioning pins
into their
positioning holes.
,rinse and sanitize
tabs on the
Push tabs
tab
Loading ...
Loading ...
Loading ...