Loading ...
Loading ...
Loading ...
iNSTALL LEVELING LEGS
Excessive Weight Hazard
Use two or more people to moveand install dryer.
Failure to do so can result in back or other injury.
i. Prepare dryer for leveling legs
To avoid damaging floor, use a large fiat piece of cardboard from
dryer carton; place under entire back edge of dryer. Firmly grasp
dryer body (not console panel) and gently lay dryer down on
cardboard.
_. Screw in leveling legs
diamond
marking ........
( )
Examine leveling legs, find diamond marking. Screw legs into leg
holes by hand, use a wrench to finish turning legs until diamond
marking is no longer visible.
Now stand the dryer on its feet. Slide the dryer until it is close to its
final location. Leave enough room to connect the exhaust vent.
ELECTRICALCONNECTION
Power Supply Cord
Fire Hazard
Use a new UL listed 30 amp power supply cord.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center
terminal (silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold).
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electrical shock.
Electrical Connection Options
. Choose electrical connection type
Power supply cord 4-wire receptacle
(NEMA Type 14-30R):
Go to "Power Supply Cord Connection."
Power supply cord 3-wire receptacle
(NEMA Type 10-30R):
Go to "Power Supply Cord Connection."
4-wire direct connection:
Go to "Direct Wire Connection."
3-wire direct connection:
Go to "Direct Wire Connection."
NOTE: If local codes do not permit connection of a cabinet-
ground conductor to neutral wire, go to "Optional 3-wire
connection." This connection may be used with either a power
supply cord or a direct wire connection.
Loading ...
Loading ...
Loading ...