Loading ...
Loading ...
Loading ...
14
Special programmes
Fluff removal cycle
The drum must be empty.
This programme is designed to clean the drying cycle of any fluff
deposits. The washer-dryer uses the flashing symbol
l (Fluff removal
cycle) in the display panel to show that this programme must be run. The
electronic cycle counter is then automatically reset. The
l Fluff removal
cycle symbol goes out after the programme starts.
To run the Fluff removal cycle programme, proceed as follows:
Make sure that the drum is completely empty and close the door.
Set the programme selector to Fluff removal cycle.
Press the Start/Pause button.
You can also run the Fluff removal cycle programme at any time without
prompting from the appliance.
Rinse + Spin:
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to $ (Rinse stop) before starting the
programme → page15.
Drain + Spin:
Drain the rinsing water following a programme with $ (Rinse stop)
→ page15.
Turn the programme selector to Drain + Spin.
Set the spin speed to $ (Rinse stop).
Press the Start/Pause button.
or
Drain and spin at the desired spin speed:
Turn the programme selector to Drain + Spin.
Press the Spin button repeatedly until the desired spin speed is set.
Press the Start/Pause button.
i
i
Loading ...
Loading ...
Loading ...