Loading ...
Loading ...
Loading ...
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that
are not the result of defective workmanship or materials in this appliance.
Before You Call
Solutions to Common Problems
OCCURRENCE POSSIBLE CAUSE/SOLUTION
Surface burners do not light Surface Control knob has not been completely turned to LITE. Push in and turn
the Surface Control knob to LITE until burner ignites and then turn control to
desired fl ame size.
Be sure gas supply valve is open.
Gas-air mixture needs a straight line to travel. Be sure burner is properly seated
in its support (models with open burners only).
Burner ports or slots are clogged. With the burner off , use a small-gauge wire
or needle to clean ports or slots.
Power cord is disconnected from outlet (electric ignition models). Be sure cord
is plugged securely into outlet.
Electrical power outage (electric ignition models). Burners can be lit manually.
See Setting Surface Controls in this Use & Care Guide.
Surface burner fl ame burns half way
around.
Burner ports or slots are clogged. With the burner off , clean ports with a small-
gauge wire or needle to clean ports or slots.
Moisture is present after cleaning. Lightly fan the fl ame and allow burner to
operate until fl ame is full. To avoid this occurrence dry the burners thoroughly
following instructions under General Care & Cleaning.
Surface burner fl ame is orange. Dust particles in main line. Allow the burner to operate a few minutes until fl ame
turns blue.
In coastal areas, a slightly orange fl ame is unavoidable due to salt air.
12
Loading ...
Loading ...