Loading ...
Loading ...
Loading ...
5
LOCATION OF PARTS
INSTALLATION INSTRUCTIONS
• Remove the exterior and interior packing.
BEFORE USING YOUR APPLIANCE
• CAUTION
• Clean the interior surface with lukewarm water using a soft cloth.
: After unpacking you MUST allow your appliance to stand upright for at least 2 hours to
allow the lubricant and refrigerant to drain back into the compressor and stabilize. Failure to do so may
adversely affect performance and the lifetime of the unit.
• Reverse the door. (See page 7.)
• The appliance is designed for free-standing installation only.
INSTALLATION OF YOUR APPLIANCE
• WARNING: Do not store or install the appliance outdoors.
• CAUTION
: This appliance is designed for storing and cooling foodstuffs. Do not store pharmaceuticals
or other medical products.
• Place your refrigerator on a floor that is strong enough to support it when it is fully loaded. To level the
unit, adjust the front leveling legs.
• For free-standing installation, leave 5 inches (127mm) of space around the back and sides of the unit
to allow proper air circulation to cool the compressor and condenser.
• NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
• Avoid locating the unit in moist areas.
• Plug the appliance into an exclusive, properly grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician or an authorized service center.
Loading ...
Loading ...
Loading ...