Loading ...
Loading ...
Loading ...
Installation
39
EN
Fixed connection
Fit the power line with an omnipolar circuit
breaker in compliance with installation
regulations.
The circuit breaker should be located near
the appliance and in an easily reachable
position.
Connection with plug and socket
Make sure that the plug and socket are of
the same type.
Avoid using adapters and shunts as these
could cause overheating and a risk of
burns.
Testing
At the end of installation, carry out a brief
inspection test. If the hob fails to operate,
after checking that you have carried out the
instructions correctly, disconnect the
appliance from the power supply and
contact Technical Support.
5.2 Safety instructions
Veneers, adhesives or plastic coatings on
adjacent furniture should be temperature-
resistant (>90°C), otherwise they might
warp over time.
The minimum distance between a ventilation
hood and the cooking surface must be at
least the distance indicated in the ventilation
hood installation instructions.
The minimum distances must also be
respected for the edges of the hob on the
back as indicated in the mounting
illustrations.
Run the power cable in the rear
part of the unit. Take care that it
does not come into contact with
the lower part of the hob or any
oven built-in underneath it.
Be careful when connecting
additional electrical appliances.
Connection cables must not come
into contact with hot cooking
zones.
Heat production during appliance
operation
Risk of fire
• Check that the piece of furniture material
is heat resistant.
• Check that the piece of furniture has the
required slots.
• Do not obstruct the ventilation grille in
front of the product in any type of
installation.
Loading ...
Loading ...
Loading ...