Loading ...
Loading ...
Loading ...
1. Press and hold the two outside
buttons releasing only when the red
light begins to flash after 20 seconds.
Do not repeat step one to program
additional hand-held transmitters to
the remaining two HomeLink威
buttons. This will erase previously
programmed hand-held transmitter
signals into HomeLink威.
2. Position the end of your
hand-held transmitter 2–8cm
(1–3 inches) away from the HomeLink威 button you wish to program
(located on your overhead console) while keeping the red light in view.
3. Simultaneously press and hold
both the HomeLink威 and hand-held
transmitter button. Do not release
the buttons until step 4 has been
completed.
Some entry gates and garage door
openers may require you to replace
step 3 with procedures noted in the
“Gate Operator and Canadian
Programming” section for Canadian
residents.
4. The red light will flash slowly and then rapidly. Release both buttons
when the red light flashes rapidly. (The rapid flashing light indicates
acceptance of the hand-held transmitters’ radio frequency signals.)
5. Press and hold the just-trained HomeLink威 button and observe the red
light. If the light is a constant red, programming is complete and your
device should activate when the HomeLink威 button is pressed and
released. Note: To program the remaining two HomeLink威 buttons,
begin with step 2 in the “Programming” section — do not repeat step 1.
Note: If the red light blinks rapidly for two seconds and then turns to a
continuous red, proceed with steps 6 through 8 to complete
programming of a rolling code equipped device.
6. At the garage door opener receiver (motor-head unit) in the garage,
locate the “learn” or “smart” button (usually near where the hanging
antenna wire is attached to the unit).
7. Press and release the “learn” or “smart” button. (The name and color
of the button may vary by manufacturer.)
2004 Grand Marquis (grn)
Owners Guide (post-2002-fmt)
USA English (fus)
Driver Controls
64
Loading ...
Loading ...
Loading ...