Loading ...
Loading ...
Loading ...
34
SPECIFICATIONS
Dryer models DLE4801W DLG4802W
Description Dryer
Electrical Requirements* Please refer to the rating label regarding detailed information.
Gas Requirements* NG 4-10.5 inches WC
LP: 8–13 inches WC (Gas Models only)
Dimensions 26.4”(W) X 29.2” (D) X 43.7” (H), 51” (D with door open)
67.1cm(W) X 74.3cm(D) X 111.0cm(H), 129.5(D with door open)
Net Weight 124.9 lbs (56.6 kg)
Drying Capacity
- Normal Cycle IEC 7.1 cu.ft. (22.5 lb/10.2 kg)
Before calling for service (cont.)
SPECIFICATIONS
USING SMARTDIAGNOSIS
TM
- Only use this feature when instructed to do so by the call center. The transmission sounds similar to a fax machine, and so has no meaning
except to the call center.
- SMARTDIAGNOSIS™ cannot be activated if the dryer does not power up. If this happens, then troubleshooting must be done without
SMARTDIAGNOSIS™.
If you experience problems with your dryer, call 1-800-243-0000 (1-888-542-2623 in Canada). Follow the call center agent’s instructions, and do
the following steps when requested:
1. Press to turn on the dryer. Do not press any other buttons.
2. When instructed to do so by the call center agent place the mouthpiece of your phone very close to the POWER button.
3. Press and hold Temp.button for three seconds, while holding the phone mouthpiece to the icon or POWER button.
4. Keep the phone in place until the tone transmission has finished. This takes about 17 seconds, and the display will count down the time.
• For best results, do not move the phone while the tones are being transmitted and do not touch the control panel with the phone.
• If the call center agent is not able to get an accurate recording of the data, you may be asked to try again.
• Pressing the POWER button during the transmission will shut off the SMARTDIAGNOSIS™.
5. Once the countdown is over and the tones have stopped, resume your conversation with the call center agent, who will then be able to assist
you using the information transmitted for analysis at the call center.
NOTE
Problem Possible Causes
Solutions
CHECK FILTER light
is on during the
drying cycle
• Lint filter is almost clogged or full. • Pause the drying cycle and clean the lint filter.
FLOW SENSE
Light is on during the
drying cycle
• Ductwork is too long or has too many turns/
restrictions.
• Significant blockage of the ductwork due to
lint buildup or debris.
• The appliance has detected a restriction in
the external dryer venting.
• Install a shorter or straighter duct run. See the Installation Instructions.
• Ductwork should be checked/cleaned soon.
Dryer can be used in this condition, but drying times may be longer.
• If exhaust restrictions are sensed by the FLOW SENSE
TM
system, the indicator
will remain on for two hours after the end of the cycle. Opening the door or
pressing the POWER button will turn off the display.
3828EL2001F_en_110524.indd 34 5/24/11 11:17:19 AM
Loading ...
Loading ...
Loading ...