Loading ...
Loading ...
Loading ...
19
Dishwasher Control Section
Dishwasher Feedback Section
Canceling A Cycle
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2. Press and hold the CANCEL/DRAIN button until the Cancel/Drain light turns on.
3. Close the door. The dishwasher starts a drain cycle if water remains in bottom of dishwasher. Let the dishwasher drain completely.
The Cancel/Drain light turns off after 2 minutes.
Delay Hours
Use this option to run your dishwasher during off-peak hours. Local utility providers recommend using energy during off-peak
hours when possible.
To delay the start:
1. Select a wash cycle and options.
2. Press DELAY HOURS to choose the number of hours to be delayed.
3. Press START/RESUME.
NOTE: Anytime the door is opened for more than 5 seconds (such as, to add a dish), the Start/Resume button must be pressed
again to resume the delay countdown.
Control Lock Option
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When Locked is lit, all buttons are
disabled. The dishwasher door can still be opened/closed while the controls are locked.
To turn on Control Lock
Press and hold SANI RINSE for 3 seconds. Locked will light. If you press any pad while your dishwasher is locked, the light flashes
3 times.
NOTE: The dishwasher cannot start if the control is locked.
To turn off Control Lock
NOTE: You may need to disable Sleep Mode by pressing either START/RESUME or CANCEL/DRAIN, or by opening and closing
the door before you are able to turn off Control Lock.
Press and hold SANI RINSE for 3 seconds. The light turns Off.
Cycle Indicators and Time Display
The indicators glow when the dishwasher is washing, drying, complete, and/or sanitized. They also glow
when the control is locked and/or the delay option is selected.
The Status Display is used to follow the progress of the dishwasher cycle and to show other information.
Estimated cycle time is displayed in hours and minutes as you make cycle and option selections. After you
start the dishwasher, the display counts down the time.
When you select the Delay option, the time display will give the number of hours followed by an “H”.
Selecting Cycles and Options
1. To repeat the same cycle/options used on previous cycle, press START/RESUME once to show which selections you used. To
change cycle, select desired cycle.
2. Select the desired options, then press START/RESUME to start the cycle. Not all options are available for every cycle. If an
invalid option is selected for a given cycle, the lights will flash.
Turning OFF/ON the Sound
Press and hold HIGH TEMP WASH for 3 seconds to toggle sound On and Off. The sound will not deactivate for cycle interruption
or service required messages.
Loading ...
Loading ...
Loading ...