Loading ...
Loading ...
Loading ...
30
Placing and Leveling
Please ensure any foam transit restraint has been removed from the machines packaging before.
If the washer is installed on an uneven, tilted, or weak timber floor causing excessive vibration,
a spin failure or “UE” error can occur.
It must be placed on a firm and level floor to prevent spin failure.
Top view of the machine
more than 10 cm
m
ore
t
han
2
c
m
more than
2 cm
Place the machine on a flat and firm surface which allows proper clearance.
We suggest a minimum clearance of 2 cm to the
right and left sides of the machine for ease of
installation.
At the rear, a minimum clearance of 10 cm is sug-
gested.
Check that the machine is level
Open the lid and look from above to see if it is
same as shown.
Leveling the machine
Lift the front of the washing machine and twist
the appropriate Adjustable Leg until the surface
bubble is (some models only) located in the
center.
1
2
3
NOTE
Adjustable legs
Caution
How to use the rubber adjusting plates
•
Use the adjusting plates to level the washer
when the adjustable legs cannot cover the gap.
If an extension cord or power board is used, ensure it is positioned so that it is not exposed to water or
moisture. This machine should be connected to a 230~240v town mains power outlet.
MFL69022796(영)호주향_150x210 16. 3. 25. 오전 9:40 페이지 30
Loading ...
Loading ...
Loading ...