Loading ...
Loading ...
Loading ...
7
5. Take out the hinge cover
handle hole caps.
Handle
hole caps.
INSTALLING THE DOOR HANDLE
This beverage cooler includes a stainless steel handle that is not required to operate the unit. To
install the handle, follow the instructions below:
1.
Remove the door gasket on the side you wish to install the
handle - you can see two designated holes for handle
installation. The gasket is easily displaced by hand, no tools
are necessary.
2.
Install the handle tightly as shown with two screws and flat
washers provided. (DO NOT over tighten as this will cause
damage to the handle and stainless steel door frame).
3.
Replace the door gasket to its original position.
Gasket
Flat Washer
Screw
Handle
Door Frame
REVERSING THE DOOR SWING (if desired)
4. Take out the caps
on the holes
1. Remove the hinge
cover, screws inside
and then the hinge at
the same time.
2. Hold tight and pull
the door upwards and
off carefully.
3. Remove the screws
and lower door hinge.
Hinge
cover
Handle
hole caps.
Hinge
cover
6. Remove
Screws
7. Take off
the handle.
8. Assemble the
hinge cover
handle hole
caps.
11. Assemble the
upper door hinge and
screws to the other
side and lock the
cover.
10. Hold tight and set
the glass door
downwards on the
lower door hinge.
12. Finished.
9. Assemble the
lower door hinge to
the other side, and
assemble the screws.
Loading ...
Loading ...
Loading ...