Loading ...
Loading ...
Loading ...
7
To replace:
1. Slide cover panel back onto posts on dispenser.
2. Align edges of dispenser with guides in washer; then slide
dispenser back into slot.
Single-Load Dispenser Drawer (on some models)
To remove:
1. Pull dispenser drawer out until it stops.
2. Press down on the release tab and pull straight out to remove
the dispenser.
3. Lift off cover panel by pulling straight up.
To replace:
1. Position cover panel back onto posts on dispenser. Apply
slight pressure on cover panel to seat it.
2. Align edges of dispenser with guides in washer; then slide
dispenser back into slot.
Cleaning Load & Go™ Containers
(on some models)
IMPORTANT: Containers are not dishwasher-safe.
It is recommended that you rinse out the Load & Go
™ containers
when refilling, when changing detergent types or concentrations,
or when the washer will not be used for an extended period.
1. Pull the dispenser drawer out until it stops.
2. Lift out the Load & Go
™ containers.
3. Lift the fill lid and flush interior thoroughly with warm water.
4. Allow to air dry.
Nonuse and Vacation Care
Operate your washer only when you are home. If moving, or not
using your washer for a period of time, follow these steps:
1. Unplug or disconnect power to washer.
2. Turn off water supply to washer to avoid flooding due to water
pressure surges.
HELPFUL TIP: Attach a reminder note to the washer to turn
the water back on before washer's next use.
3. Clean the dispensers. See “Cleaning the Dispensers.”
Winter Storage Care
IMPORTANT: To avoid damage, install and store washer where it
will not freeze. Because some water may stay in hoses, freezing
can damage washer. If storing or moving during freezing weather,
winterize your washer.
To winterize washer:
1. Shut off both water faucets; disconnect and drain water inlet
hoses.
HELPFUL TIP: Attach a reminder note to the washer to turn
the water back on before washer’s next use.
2. Remove drain pump filter.
3. Put 1 qt. (1 L) of R.V.-type antifreeze in drum and run washer
on Normal cycle for about 2 minutes to mix antifreeze and
remaining water.
4. Unplug washer or disconnect power.
Loading ...
Loading ...
Loading ...