Loading ...
Loading ...
Loading ...
The signal is not detected during program-
ming. Comparable with Canadian law, some
U.S. garage door openers also feature a
"break".
Proceed as follows:
R
if you live in Canada
R
if you have difficulties programming the
garage door opener (regardless of where
you live) as you follow the programming
steps.
X
Press and hold one of buttons ; to ? on
the integrated garage door opener.
After a short time, indicator lamp : lights
up yellow.
X
Release the button.
Indicator lamp : flashes yellow.
X
Press button B of garage door remote con-
trol A for two seconds, then release it for
two seconds.
X
Press button B again for two seconds.
X
Repeat this sequence on button B of
remote control A until indicator lamp :
lights up green.
When indicator lamp : lights up green:
programming is finished.
When indicator lamp : flashes green: pro-
gramming was successful. The next step is
to synchronize the rolling code.
X
Release button B of remote control A of
the garage door drive.
If indicator lamp : lights up red: repeat the
programming process for the corresponding
button on the rear-view mirror. When doing
so, vary the distance between remote con-
trol A and the rear-view mirror.
The required distance between remote con-
trol A and the integrated garage door
opener depends on the garage door drive
system. Several attempts might be neces-
sary. You should test every position for at
least 25 seconds before trying another posi-
tion.
Problems when programming
If you are experiencing problems programming
the integrated garage door opener on the rear-
view mirror, take note of the following instruc-
tions:
R
Check the transmitter frequency used by
garage door drive remote control A and
whether it is supported. The transmitter fre-
quency can usually be found on the back of
remote control A for the garage door drive.
The integrated garage door opener is com-
patible with devices that have units which
operate in the frequency range of 280 to
433 MHz.
R
Replace the batteries in garage door remote
control A. This increases the likelihood that
garage door remote control A will transmit
a strong and precise signal to the integrated
garage door opener.
R
When programming, hold remote control A
at varying distances and angles from but-
tons ; to ? which you are programming.
Try various angles at a distance between
2and 8 inches (5to 20 cm) or at the same
angle but at varying distances.
R
If another remote control A is available for
the same garage door drive, repeat the
same programming steps with this remote
control A. Before performing these steps,
make sure that new batteries have been
installed in garage door drive remote control
A.
R
Note that some remote controls only trans-
mit for a limited amount of time (the indica-
tor lamp on the remote control goes out).
Press button B on remote control A again
before transmission ends.
R
Align the antenna cable of the garage door
opener unit. This can improve signal recep-
tion/transmission.
Opening/closing the garage door
After it has been programmed, the integrated
garage door opener performs the function of
the garage door system remote control. Please
also read the operating instructions for the
garage door system.
X
Turn the SmartKey to position 2 in the igni-
tion lock (Y page 125).
X
Press button ;, = or ? which you have
programmed to operate the garage door.
Garage door system with a fixed code: indi-
cator lamp : lights up green.
Garage door system with a rolling code: indi-
cator lamp : flashes green.
The transmitter will transmit a signal as long
as the button is pressed. The transmission
270
Features
Stowage and features
Loading ...
Loading ...
Loading ...