Loading ...
1
INSTALLATION INSTRUCTIONS
Before Using Your Freezer
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
1 Storage Basket
1 Instruction Manual
1 Plastic Scraper（optional）
Before connecting the freezer to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Installing Your Freezer
This appliance is designed to be free standing only, and should not be recessed or built-in.
Place your freezer on a floor that is strong enough to support the freezer when it is fully
loaded.
Allow 15 cm of space between the back and sides of the freezer, which allows the proper
air circulation.
Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the freezer
not to perform properly.
Avoid locating the freezer in moist areas.
Plug the freezer into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician or an authorized service center.
After plugging the appliance into a wall outlet, allow the unit to cool down for 2~3 hours
before placing food in the freezer compartment.
Electrical Connection
For your safety please read the following information
OPERATING YOUR FREEZER
Temperature Control
Your freezer has one control for regulating the temperature. The temperature control
is located on the lower right hand corner.
· The range of the temperature control is from position “MIN, MAX and OFF”.
Adjust the temperature control to the setting that best suits your needs.
· To turn the freezer off, turn the temperature control to "OFF".
NOTE:
Turning the temperature control to "OFF " position stops the cooling cycle but does not
shut off the power to the freezer.
If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the freezer will not start.
Large amounts of food will lower the cooling efficiency of the appliance.
If you choose to change the thermostat setting, adjust thermostat control by one
numerical increment at a time. Allow several hours for temperature to stabilize between
adjustments.
Loading ...
Loading ...
Loading ...