Loading ...
Loading ...
Loading ...
15
2 3
15 mins
15 mins
8
6
5
1
2
1
1
2
1
Re-assemble. Wipe the exterior with a lint-free
microfiber cloth. Switch ‘ON’: the water treatment
procedure starts. After 3 minutes the machine will
start to humidify.
Using a damp cloth, wipe over both sections with the
citric acid solution. Do not put in a dishwasher or rinse
under the tap.
To attach the loop amplifier surround, lie flat and align
the surround to the main amplifier. Push firmly until it
clicks into place as shown.
dishwasher. Fill the trough with the recommended acid citric
solution until the UV-C emitter and piezo are submerged.
Leave for 15 minutes. Drain, rinse and wipe over all surfaces.
Repeat if necessary.
To remove the seal, pinch the securing tabs together and pull
out. Clean thoroughly by immersing in the recommended
citric acid solution for 15 minutes. Rinse and wipe over all
surfaces. Repeat if necessary. To refit, push back in so the
tabs click and the fit is secure.
Pour in the recommended citric acid solution. Replace the
cap and shake tank for 30 seconds. Then leave to stand.
After 15 minutes, empty the tank. Rinse and wipe over all
surfaces. Repeat if necessary.
UV-C emitter
Piezo
Some cleaning chemicals are harmful to the machine
and should not be used. Use of these may invalidate
your warranty. Do not use: Alcohol and strong acid
mixes, solvent (acetone) and oil based products, alkali
bleach mixes, air fresheners, aroma oils, scented oils,
hot water, brushes, abrasive materials, etc. Please do
not put in a dishwasher or close to a fire.
Loading ...
Loading ...
Loading ...