Loading ...
Loading ...
Loading ...
HEADLIGHT HOUSING REPLACEMENT
(570 / 570 EPS / X2)
1. Remove the two screws on the lower front corners of the headlight pod.
2. Lift the pod slightly while depressing the tabs at the rear of the pod.
3. Lift the pod cover and disconnect the speedometer harnesses from the
speedometer.
4. Unplug the headlamp from the wiring harness.
5. Use a small screwdriver to remove the o-rings from the headlight mounting
tabs.
6. Pull the headlight housing up to release it from the locking tabs.
7. Lift the adjusting knob up to remove it from the locking tabs.
8. Carefully pull the assembly up and out of the pod.
9. Reverse the steps to install the new housing and reassemble the pod. The
distance from the headlamp parting line to the end of the adjustment knob
stop is 13 cm (5 1/8”)
q
.
10.Adjust the headlight aim by turning the adjustment knob.
140
MAINTENANCE
Loading ...
Loading ...
Loading ...