Loading ...
Loading ...
Loading ...
Not all features are on all models.
To Set the Timer
The timer does not control oven operations.
The maximum setting on the timer is 9 hours
and 59 minutes.
Touch the TIMER/CLOCK pad.
Touch the + or – or the number pads
until the amount of time you want
shows in the display. The maximum
time that can be entered in minutes
is 59. Times more than 59 minutes
should be changed to hours and
minutes. For example, to enter 90
minutes as 1 hour 30 minutes, touch
1, 3 and 0 in that order.
If you make a mistake, touch the TIMER/CLOCK
pad and begin again.
Touch the START pad. After touching
the START pad, SET disappears; this
tells you the time is counting down,
although the display does not change
until one minute has passed.
When the timer reaches :00, the
control will beep 3 times followed by
one beep every 6 seconds until the
TIMER/CLOCK pad is touched.
The 6 second tone can be canceled by following
the steps in the Special features of your oven control
section under Tones at the End of a Timed Cycle.
The timer is a minute timer only.
The CLEAR/OFF pad does not affect
the timer.
Using the clock and timer. www.GEAppliances.com
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of day
cannot be changed during a timed baking
or self-cleaning cycle.
Touch and hold the TIMER/CLOCK pad
until the display changes.
Depending on which model you have,
you will set the clock by touching
either the + or – or the number pads.
Touch the number pads the same way you
read them. For example, to set 12:34, touch
the number pads 1, 2, 3 and 4 in that order.
If number pads are not touched within one
minute after you touch the TIMER/CLOCK
pad, the display reverts to the original
setting. If this happens, press and hold the
TIMER/CLOCK pad and reenter the time
of day.
Touch the START pad until the time
of day shows in the display. This enters
the time and starts the clock.
To check the time of day when the display is
showing other information, simply press and hold
the TIMER/CLOCK pad until the time is displayed.
The time of day shows until another pad is touched.
Make sure the clock is set to the
correct time of day.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by touching
the TIMER/CLOCK pad, then touch the + or
– or the number pads until the time you
want appears in the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the TIMER/CLOCK pad and then
touching the number pads to enter the
new time you want.
To Cancel the Timer
Touch the TIMER/CLOCK pad twice.
Power Outage
If a flashing time is in the display, you have
experienced a power failure. Reset the clock.
To reset the clock, touch and hold the
TIMER/CLOCK pad until the display changes.
Enter the correct time of day by touching
the + or – or the appropriate number
pads. Touch the START pad.
Consumer SupportOperating InstructionsSafety Instructions Installation Instructions Troubleshooting Tips
15
Loading ...
Loading ...
Loading ...