Loading ...
Loading ...
Loading ...
Consumer Support Troubleshooting Tips
Operating Instructions Safety Instructions
Troubleshooting Tips
Care and Cleaning Safety InstructionsOperating Instructions
Make sure the drain connector is capped and in
the up position. When the bucket is removed, the
unit will shut off. Empty and replace the bucket,
making sure that it is fully seated in the unit.
IMPORTANT: When using the water bucket to remove
collected water, make sure that the drain connector is
in the up position and that it is capped. If it is not in the
up position water will drain from the connector onto the
floor.
When the water bucket is full, a signal will beep
and the display will show E4 until the water bucket
has been emptied.
NOTE: The fan will continue to operate even when
the water bucket is full. However, the Cooling or Dry
mode will not work until the water bucket has been
emptied and replaced correctly.
To empty the water bucket before it is full, turn the
unit off and wait for three minutes for all water to
collect into the bucket.
Always make sure the water bucket is locked into place on the portable air conditioner.
Using the portable air conditioner.
Using the Water Bucket
Using the Drain Hose
Water can be automatically emptied into a floor
drain by uncapping the drain connector, tilting it
down and connecting the drain hose. Route the
drain hose straight to a floor drain.
IMPORTANT: When the drain connector is tilted down
the water will drain through the connector. Make sure
the hose is connected and that it is led straight to a
floor drain. Never tilt the drain connector down with it
capped because draining water will cause the unit to
malfunction.
6
Water
bucket
Drain
connector
in up and
capped
position
for water
bucket use.
When tilting the drain connector down, always uncap it, attach the drain
hose and lead it straight to a floor drain.
Tilt down
and
connect
hose to
drain.
Cap
How to Insert the Batteries in the Remote Control
Remove the battery cover by sliding it
according to the arrow direction.
Insert new batteries, making sure that the (+)
and (–) of battery are installed correctly.
Reattach the cover by sliding it back
into position.
NOTES:
■ Use 2 “AAA” (1.5 volt) alkaline batteries. Do not
use rechargeable batteries.
■ Remove the batteries from the remote control if
the system is not going to be used for a long time.
3
2
1
Loading ...
Loading ...
Loading ...