Loading ...
Loading ...
Loading ...
9
CONNECTION
INSTALLATION
• Choose the suitable place. Locate the
refrigerator in a place convenient for its use;
• The refrigerator is not a built-in appliance.
Free space not less than 5 cm should be
provided from above, from its rear and side
faces for air circulation and reduction of
power consumption. Fig.1;
• Do not install the refrigerator near heat
sources and in a zone exposed to direct
sunlight or high humidity;
• Make sure that electrical voltage indicated
in the manual meets the parameters of
your mains;
• Do not remove the round stickers on the
rear side of the refrigerator.
They have a decorative function closing
the fabrication holes;
• To exclude vibration, check the refrigerator
• To ensure proper air circulation around the
fridge -freezer, please maintain sufficient
space on both the sides as well as top and
maintain at least 2 inches (5cm) from the
rear wall.
installation using a level. If necessary, turn
the adjustable feet to compensate irregularity
of the floor.
To ensure better closing of the door, the
refrigerator should be slightly inclined
backwards. To turn the adjustable feet,
slightly incline the refrigerator.
To raise the front part of the refrigerator,
turn the adjustable feet counter-clockwise
( )to lower it – turn them clockwise( );
• Before use, carefully wash the refrigerator;
• Install the removable parts, such as ice tray,
etc. to the appropriate places.
It is necessary to prevent possible damages
during transportation;
• Insert the power cord plug to the power
outlet. Do not power other electric appliance
from the same outlet.
After first installation of the refrigerator, let it
work for 2-3 hours for stabilization of the
operating temperature inside and only then
fill the refrigerator with fresh or frozen
foodstuffs. After disconnection of the
refrigerator from the mains, wait at least 5
minutes to switch on it again. Now, the
refrigerator is ready for service.
This appliance contains fluid (refrigerant,lubricant)
and is made of parts and materials which are
reusable and/or recyclable.
All the important materials should be sent to the
collection centre of waste material and can be
reused after rework(recycling).
For take back,please contact with the local agency.
If LED lamp is damaged,it should be replaced
by the service center in stead of on your own.
•
Lamp Replacement
Disposal of the old appliance
Climate Class
The applicance is designed to operate at the
limited range of ambient temperature,
depending on climate zones.Do not use the
applicance at the temperature out of the limit.
Climate class of your applicance is indicated
on the label with technical description inside
the fridge compartment.
Do not move refrigeratoe while the
refrigerator is operating.
Compressor may occur a temporary rattling
noise.(This is normal and will not impact on
the performance or the life of the
compressor.The rattling will stop after the
refrigerator comes to a rest.)
Loading ...
Loading ...
Loading ...