Loading ...
Loading ...
Loading ...
9
EN
4. INSTALLING YOUR NEW APPLIANCE
Unpacking
ENVIRONMENT
Most of the packing materials are
recyclable. Please dispose of those
materials through your local recycling
depot or by placing them in
appropriate collection containers.
Important – check for any damages or
marks. If you find the refrigerator is damaged
or marked, you must report it within 7 days
should you wish to claim for damage/marks
under the manufacturers warranty. This does
not aect your statutory rights.
Clean your refrigerator thoroughly following
the instructions in the “Cleaning” section
and wipe o any dust that has accumulated
during shipping.
Locating the refrigerator
CAUTION
Automatic aerosol systems (such as
insect control) should not be located
adjacent to the product as the spray
may cause long term damage to the
external plastics of the appliance.
Do not put the refrigerator in a location that
is too cold or is unprotected, for example in
a garage or on a veranda. The ambient
temperature should be above 10°C.
Put the refrigerator in a dry place avoiding
areas of high moisture or humidity.
Ensure the refrigerator is located on an even
surface.
Adequate ventilation around your
refrigerator
The diagram below shows the recommened
airspace to allow for ventilation of your
refrigerator.
• Allow a minimum of 30mm clearance on
both sides of the refrigerator.
• Allow 50mm clearance at the back of the
refrigerator.
• Allow a minimum of 10mm clearance
above the hinge cover.
• If you do not have a cupboard with
allowance for air flow above the
refrigerator, the recommended clearance
area on top increases to 90 mm.
• When positioned in a corner area, spacing
of at 350mm on the hinge side will allow
the doors to open enough to enable the
removal of bins and shelves.
NOTE: In installation where both sides and
the rear of the refrigerator are not enclosed
by cabinetry e.g. the refrigerator is placed
against a wall, the clearance between the
rear of refrigerator and the wall should not
be greater than 75mm.
You refrigerator uses energy efficient
components that may produce dierent
noises (Refer “Noises” page for examples) to
your old refrigerator. Occasionally a gurgling
sound of refrigerator flowing or the sound
of parts expanding and contracting can be
heard. These noises are quite normal.
350mm
30mm
30mm
DOOR
CABINET
airspace
Recommended
50mm
90 mm
10 mm
Height adjusting nut
Fixed rear rollers
10-15mm
aligned to
cupboards
ie. even gap
top of refrigerator is
level ie. horizontal
uneveness of floor
adjust front feet for
eg. wind this foot
stability foot
down or up
wound up
Loading ...
Loading ...
Loading ...