Loading ...
Loading ...
Loading ...
Crisper Operation
CONCERN WHAT TO DO
Excess moisture build up in crisper
It is normal for there to be some
moisture and humidity in the crisper bin.
Ensure that the crisper is not over packed.
Adjust crisper humidity slides.
Crisper bin can not be removed If crisper bin interferes with the door bins, remove door bins before
removing crisper.
Position cabinet so that the door can be fully opened.
Freezing items in the crisper Adjust temperature to a warmer setting.
Refrigerator operation
CONCERN WHAT TO DO
Appliance will not run
It is normal for the freezer fan not to
operate during the automatic defrost
cycle, or for a short time after the
appliance is switched on.
Ensure that the cord is plugged into a live power outlet and outlet is
switched on.
Ensure that the household circuit breaker has not tripped or that the fuse
has not blown.
The appliance maybe in defrost mode, check again in half an hour.
Compressor motor seems to run
too long
At normal room temperatures, expect
your motor to run about 40% to 80%
of the time. Under warmer conditions,
expect it to run more often.
Ensure that the doors are not held open
Check that large amounts of warm food have not just been placed inside
the appliance.
Note that the appliance will run more than normal just after you install it or
when adjusting the temperature setting changes.
Compressor motor seems to run too
long for WHE6000, WHE6060,
WQE6000 and WQE6060 only.
These appliances use a variable
speed compressor, which by design
can run for long periods of time, this
is normal
The variable speed compressor and fan that at start up and on warm days,
runs at high speeds to provide additional cooling. When less cooling is
required the compressor and fan will run at a lower speed, but still may
not switch off. This is normal.
It is possible that the only time the compressor and fan will stop is when
the refrigerator is defrosting which is approximately once per day.
The exterior of the appliance is warm
or hot to touch
This is normal because the appliance
transfers heat from the inside out
through the outer panels and the
divider between the doors.
Ensure the appliance has the external clearances recommended in the
section “Installing your new appliance”.
The exterior of the cabinet will be much warmer on warmer days it may
even feel hot to touch, as the appliance is working harder.
User interface will not respond
To ensure settings are not accidentally
changed the user interface will go into
sleep mode when not in use. Press any
button to wake user interface
Check that the user interface is in awake mode, refer to section “About the
user interface”.
Check that the user interface is not locked, refer to section “About the
user interface”.
If the user interface is frozen turn the appliance off for five minutes for the
memory to clear, then turn back on.
Check that the user interface is not in Sabbath Mode, refer to control
instructions. (I&W models only).
TROUBLESHOOTING
TROUBLESHOOTING 29
Loading ...
Loading ...
Loading ...