Loading ...
Loading ...
Loading ...
4
1
6
Control Panel and Features
WASH TEMPERATURE
Wash Temperature senses and maintains uniform water
temperatures by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric
and soils being washed. For best results, and following
the garment label instructions, use the warmest wash
water safe for your fabric.
■ On some models and cycles, warm and hot water may
be cooler than your previous washer.
■ Even in a cold- and cool-water wash, some warm water
may be added to the washer to maintain a minimum
temperature.
All rinses are cold.
FABRIC SOFTENER
This option must be set to “Yes” if you are using fabric
softener in the fabric softener dispenser. This ensures that
fabric softener is added at the correct time in the rinse for
even distribution.
WATER LEVEL
Set the Water Level knob to the Auto Sensing setting and
the washer will ll to a level that ensures the load engages
the agitator. From this point, the electronic control will sense
the load and determine if additional water is needed.
Set the Water Level knob to the Deep Water Wash setting
and the washer will ll to the maximum water level.
NOTE: Expect longer cycle times due to extended ll times
when using the Deep Water Wash option.
WASH CYCLE KNOB
Use the wash cycle knob to select cycles on your washer.
See “Cycle Guide” for detailed descriptions of cycles.
1
2
3
4
START/STOP BUTTON
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several minutes
to unlock the lid. Press and hold for 3 seconds to cancel
a cycle.
CYCLE STATUS LIGHTS
The Cycle Status Lights show the progress of a cycle.
At each stage of the process, you may notice sounds or
pauses that are different from your previous washer.
SENSING/FILL
When the Start/Stop button is pressed and the Water
Level knob is set to Auto Sensing, the washer will ll
and begin sensing to determine load size and balance.
Once sensing is complete, the washer will ll to the
appropriate level for the detected load size and then
begin the wash phase of the cycle.
NOTE: Sensing and wash phases will be paused by
opening the unlocked lid. Close the lid to resume the
cycle. If the lid is left open for more than 10 minutes,
the washer will cancel the cycle and pump out the water.
The lid will lock after the wash phase to begin the initial
spinout and remain locked for the remainder of the cycle.
5
6
Not all features and options are available on all models.
Appearance may vary.
4
3
2
5
Loading ...
Loading ...
Loading ...