Loading ...
Loading ...
Loading ...
14
Connect Outlet Hose
1. Attach hose
Attach the goose neck tting of the provided 6' (1829 mm)
drain hose to the drain valve at the bottom of dryer back
panel. Screw on coupling by hand until it is seated on valve
connector.
2. Tighten coupling
Using channel locks, tighten the coupling an additional
two-thirds turn.
NOTE: Do not over tighten. Damage to the coupling can
result.
Level Dryer
1. Level dryer
Place
level here
Not Level LEVEL Not Level
Check levelness of dryer from
side to side. Repeat from front to back.
NOTE: The dryer must be level for the moisture sensing
system to operate correctly. If forward slope of dryer is
greater than 1" (25 mm), water could run out from front
of lter.
4.5"
(114 mm)
4.5"
(114 mm)
4.5"
(114 mm)
4.5"
(114 mm)
4.5"
(114 mm)
4.5"
(114 mm)
3. Secure drain hose system
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie.
Laundry Tub Standpipe Wall
2. Adjust leveling legs
If dryer is not level, prop up using a wood block, use wrench
to adjust legs up or down, and check again for levelness.
Once dryer is level, make sure all four legs are snug against
the oor and dryer does not rock.
Loading ...
Loading ...
Loading ...