Loading ...
Loading ...
Loading ...
Water softening system / special salt en-us
15
+ Water softening
system / special salt
Wat er s of t eni ng syst em / spec i al sal t
To ensure good rinsing results, the
dishwasher requires soft water, i.e.
water which is low in lime, otherwise
limescale will be deposited on the
utensils and interior container. Tap
water above 7° dH (1.2 mmol/l)
must be softened. The water
is softened with special salt
(regeneration salt) in the water
softening system of the dishwasher.
The setting and therefore the
required amount of salt depends on
the degree of hardness of your tap
water (see following water hardness
table).
Water hardness table
Adjusting the water
softening system
The amount of salt dispensed can be
set from 0 to 62°E. Salt is not
required at the set value 0-8.
Set the softening system as follows:
1.
Ask your local water utility
company for the water hardness
value of your tap water or use test
strip.
2.
Required setting can be found in
the water hardness table.
3.
Open the door.
4.
Switch on On/Off switch (.
5.
Press Info button 8 for
3 seconds until the following text
is indicated on the display window
at the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
6.
Keep pressing button > )* until
the water hardness is indicated
on the display window at the top
@.
7.
Make the selection with setting
buttons + - X.
8.
Press and hold the Info button
8 for 3 seconds.
The chosen setting has now been
stored.
Greeting On When switching on the appliance, the brand logo can
be deselected.
Factory setting Reset Resetting to the factory setting.
Setting Factory setting Infotext
by pressing Info button
* depending on the features of your dishwasher
:DWHU
KDUGQHVV
YDOXH(
VRIW
PHGLXP
KDUG
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
PPROO
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
Ȣ
6HWYDOXH
RQWKH
PDFKLQH
+DUGQHVV
UDQJH
KDUG
KDUG
PHGLXP
PHGLXP
VRIW
Loading ...
Loading ...
Loading ...