Loading ...
Loading ...
Loading ...
33
CARE AND CLEANING
To clean burner heads:
1. Remove the burner cap from the burner head (see
Figure 20). Clean the cap with hot soapy water and dry
thoroughly.
2. For burned-on and dried spills, apply hot soapy water to
the burner head. Allow time for the soils to soften.
3. Use a toothbrush to clean all over the burner head (see
Figure 21).
4. Use the toothbrush to clean the slots and holes in the
burner (see
Figure 21).
5. Use a needle or fine wire to clean out the ignition port
(see
Figure 21).
6. Wipe the burner head clean with a soft, clean cloth,
sponge, or scratch-free cleaning pad.
7. Before using the cooktop again, make sure the burner
caps are properly placed and seated on the burner
heads. When placed correctly, the burner cap is
centered on the burner head and will click into place on
the burner head. You can wiggle the cap to test place
-
ment, it should not move off the burner head (see
“Assembly of the burner caps” on page 13).
Important notes:
• The surface burner heads are secured to the cooktop
and must be cleaned in place on the cooktop.
• Always keep the surface burner caps in place whenever
a surface burner is in use.
• When replacing the burner caps, be sure the burner
caps are seated firmly on top of the burner heads.
• For proper flow of gas and ignition of burners do not
allow spills, food, cleaning agents, or any other material
to enter the gas orifice port opening.
Figure 20: Burner Cap
Figure 21: Sealed burner components
Burner Cap
Burner Head
Burner Cap Lip
orifice port
slots
ignition port
ignitor
Loading ...
Loading ...
Loading ...