Loading ...
Loading ...
Loading ...
12
Install Range Hood
1. Remove the power supply knockout from the top or rear of
the vent hood (depending on the incoming location of your
home power supply cable) and install a UL Listed or CSA
Approved ¹⁄
2
" strain relief.
A. Power supply knockout
2. Align the exterior edge of the mounting brackets with the
exterior edges of the upper cabinet.
IMPORTANT: The brackets should touch the upper cabinet.
With a pencil, mark the upper holes on the brackets.
3. Using a #2 Phillips screwdriver, install the drywall anchors.
Using #8-18 x 1" (4.2 x 25 mm) flat-head #2 Phillips screws,
install the mounting brackets using the upper holes.
NOTE: For installation to a surface other than drywall, it
is recommended that a qualified contractor determine the
anchoring method.
4. With the aid of a 4.5 x 13 mm screw, mount 2 brackets on
the inside front or side face of the cabinet, flush with the
cabinet bottom.
7. (Optional) Insert a #8-18 x
5
⁄
8
" (4.2 x 16 mm) screw into the
mounting tab (A) on each side of the range hood shown in
the following image.
A. #8-18 x
5
/
8
" (4.2 x 16 mm) screw
6. Mount a round washer and a 4.5 x 13 mm screw to install the
mounting brackets on the front of the cabinet.
A. #8-18 x
5
/
8
" (4.2 x 16 mm) screw
B. Washer
A
A
B
A. Cabinet front face edge
B. Rear installation bracket marks
5. Lift the range hood into place, positioning the rear slots over
the mounting brackets.
A
Loading ...
Loading ...
Loading ...