Loading ...
Loading ...
Loading ...
Check list for washer
operation
Check the following if the washer is
not operating properly:
1. Power supply cord is plugged in.
2. Circuit breaker is not tripped or fuse
blown.
3. Timer has been advanced to start
of a cycle.
4. Water faucets are turned on.
5. Inlet and drain hoses are not
kinked.
6. Washer lid is closed.
7. Inlet valve is frozen if not sheltered
from the weather.
8. Suds level. Excess suds will slow the
spin and cause poor rinsing.
Operate the washer through a
complete cycle with no detergent.
Use less detergent or a controlled
suds type detergent in future loads.
PAGE 7
Additional features
Disconnect power before making
electrical connections.
Failure to do so can result in death
or electrical shock.
Electrical Shock Hazard
WARNING
For WARM RINSE where applicable:
• Remove screws from each end of
the console bottom.
• Pull the console bottom forward;
lift and tilt back.
• Connect J1 to J2
To SAVE WATER where applicable:
• Locate water level switch on
back of washer. (See Back Page.)
• Turn shaft 45° counterclockwise.
If you need
assistance…
T
he Whirlpool
®
C
ommercial Laundry
Trade Partner Support Center will
answer any questions about
operating or maintaining your washer
not covered in the Installation
Instructions. The Whirlpool
®
Commercial Laundry Trade Partner
Support Center is available by dialing
1-800 NO BELTS (1-800-662-3587) —
t
he call is free.
When you call, you will need the
washer model number and serial
number. Both numbers can be found
on the serial-rating plate located on
your appliance.
22.F
or electro/mechnical
models only. Check the wash cycle
time. The washer has a 9-minute wash
in the Normal Cycle. Remove the
timer from the meter case of the
washer to manually start the timer.
Start the washer and allow it to
complete the Normal cycle.
Timers can be started by turning the
clutch assembly counterclockwise
until the washer starts to fill with water.
23.If the washer fails to start or
does not give the proper washer
cycle time, the clutch assembly of the
timer can be adjusted. Remove the
timer from the meter case. Adjust the
clutch assembly screw clockwise if
the washer does not start after the
coin slide mechanism has been fully
actuated in or out. Adjust the clutch
assembly counterclockwise if the
washer segment of the Normal cycle
was less than 9 minutes.
Timer-front view
Rotate
counterclockwise
only.
Timer "off" position
Timer clutch
adjustment screw
8315954 Rev B ENv06:YC10665/8315954A 5/3/10 11:04 AM Page 7
Loading ...
Loading ...
Loading ...