Loading ...
Loading ...
Loading ...
22
Reinstall the side interlock button removed in step 7.
Center the spring in the compartment and insert the
interlock button on top of it.
Clean the glass on the door and door cover, if
necessary.
Make sure the three gray interlock buttons are
properly installed and that the top and side lock
rods are properly aligned where they meet. Carefully
lower the door cover into place, aligning the holes
in the cover with the interlock buttons on the top
and side and the bumpers on the bottom. Take care
not to dislodge the lock rods while mounting the
door cover. Once the door cover is in place, secure it
with the 12 screws removed in step 4. The ten similar
screws go around the top and sides of the door
cover. Make sure to install the two different screws
on the bottom edge, in the locations marked below.
Interlock
buttons
Side interlock
button
Bumpers
Press in the side interlock button on the left side and
hold it down while you press the hinge pivot into
the hinge assembly on the top right side. If the door
has been reassembled correctly, the lock rod will
slide back easily and lock the pivot in place. The door
is now ready to remount on the opposite side of the
dryer.
Two large
screws
Two small
screws
While supporting the door, install the two small
hinge screws removed in step 2. Test the swing of the
door to make sure the hinges and latch are properly
aligned and that the door opens, closes and latches
properly in both directions.
If the door doesn’t operate smoothly, remove the
door and then the door cover to check that the lock
rods and interlock buttons are properly mounted and
aligned. The interlock buttons should be oriented
correctly and operating smoothly. The interlock rods
should be in the proper position and should not
overlap at the contact point. (See steps 15-17.)
If the door is damaged, or if the door does not work
after reassembly, contact the call center at 1-800-243-
0000.
INSTALLATION INSTRUCTIONS
Loading ...
Loading ...
Loading ...