Loading ...
Loading ...
Loading ...
10
5
23
6
1
4
Fan switch
Thereby a climate which corresponds to that of a wine cellar is
achieved inside the appliance. Corks are prevented from drying
out due to an increased level of humidity.
Switching on: Press the Ven-
tilation button. The symbol
will light up.
Switching off: Press the Ven-
tilation button again. The
symbol will go out.
Setting the temperature
To reduce the temperature:
Press the Down button.
To increase the temperature:
Press the Up button.
- While you are entering the tem-
perature, the set temperature
will flash on the display.
- You can change the settings in increments of 1°C briefly pressing
the button again.
- The electronic controls will switch over automatically about 5 sec-
onds after the last time you pressed the button, and the actual
temperature will be displayed.
The temperature can be set at between +5°C and +20°C.
8 7
bl 9
Operating and control elements
The electronic control panel has the new "touch capacitance
technology". Any function can be activated by touching the cor-
responding icon.
The exact contact point
is between the symbol and its label
Switching the appliance on an off
Switching on: Press the On/Off button
so that the temperature display lights
up/flashes.
Switching off: Press the On/Off but-
ton for approx. 3 seconds so that the
temperature display goes out.
Setting up
• Standard EN 378 specifies that the room in which you install your
appliance must have a volume of 1 m
3
per 8 g of R 600a refrigerant
used in the appliance, so as to avoid the formation of inflammable
gas/air mixtures in the room where the appliance is located in the
event of a leak in the refrigerant circuit. The quantity of refrigerant
used in your appliance is indicated on the type plate on the inside
of the appliance.
• Do not connect the appliance to the supply with other equipment
using an extension cable - risk of overheating.
Connecting to the mains
Power supply (AC) and voltage at the operating point must comply
with the details on the type plate, which is located inside the appli-
ance on the left-hand side. The socket must be fused with a 10 A
fuse or higher, it must be away from the rear of the appliance and
must be easily accessible.
Connect the appliance with a properly earthed fused plug
and socket only.
The wires in the mains lead are coloured in accordance with the
following code: green/yellow = earth, blue = neutral, brown = live.
Warning! This appliance must be earthed.
Operating elements
Appliance ON/OFF
Temperature setting buttons
Interior light ON/OFF
Mute alarm
Fan ON/OFF
Temperature display
Control elements
Interior light ON symbol
Alarm symbol
Child lock activated symbol
Fan ON symbol
Loading ...
Loading ...
Loading ...