Loading ...
Loading ...
Loading ...
49-80404-4 7
Care and Cleaning
Chimney Vent Hood
For your
safety
Before servicing or cleaning unit, switch power
off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally.
When the service disconnecting means cannot
be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
Metal grease
filters
Charcoal
filter
(on some
models)
The metal filters trap grease released by foods
on the cooktop. The filters also help prevent
flames (from food, grease) from damaging the
inside of the hood.
For this reason, the filters must ALWAYS be
in place when the hood is used. The grease
filters should be cleaned every 6 months, or
as needed.
To clean the grease filters, soak them and then
swish them around in hot water and detergent.
Don’t use ammonia or ammonia products
because they will darken the metal. Do not
use abrasives or oven cleaners. Light brushing
can be used to remove embedded dirt. Rinse,
shake and let them dry before replacing.
The metal grease filters may also be cleaned
in an automatic dishwasher.
To remove:
Pull the visor out. Grasp the filter lock and
pivot it open to release. Pull the filter down and
out. Remove both filters.
To replace:
1. Insert the two tabs on the bottom filter edge
into the slots in the back of the hood.
2. Push the front of the filter up, open the filter
lock and snap it into place in the hood.
If the model is not vented to the outside,
the air will be recirculated through a
disposable charcoal filter that helps remove
smoke and odors.
The charcoal filter should be replaced when it
is noticeably dirty or discolored (usually after 6
to 12 months, depending on hood usage).
NOTE: DO NOT rinse, or put charcoal filter in
an automatic dishwasher.
The charcoal filter cannot be cleaned. It
must be replaced.
Order Charcoal Filter WB02X11343.
This filter can be ordered from your Monogram
Supplier.
To remove:
1. Pull the visor out.
2. Remove the two metal filters—see Metal
grease filters section above.
3. Grasp the front of the charcoal filter and pull
it down and out.
To replace:
Insert the back of the charcoal filter edge into
the opening in the rear (center), push the front
of the filter up and snap it into place in the
hood. Replace the two metal filters.
Filter Locks
Loading ...
Loading ...
Loading ...