Loading ...
Loading ...
Loading ...
5
4. When the display gets down to one bar, it’s a good idea to check that you’ve got another
filter cartridge available. If you haven’t, it’s time to buy some.
5. The flashing dot at the bottom right of the display shows that the Memo is working.
FILLING
1. Press the lid lock, to open the lid.
2. Fill with at least 2 cups of water, but not above max.
3. If you overfill, the kettle may spit boiling water.
4. Fill the funnel quickly.
5. Fill it again when it empties.
6. This should fill the kettle to about the max mark
7. If the water level is above the max mark, pour some water out of the kettle.
8. Close the lid, and press down to lock it.
USING YOUR KETTLE
1. Put the stand on a stable, level surface.
2. Plug the stand into the wall socket.
3. Put the kettle on the stand.
4. Move the switch to I.
5. The light will come on. The kettle will start to heat.
6. When the water boils the kettle will switch off.
7. To switch off manually, move the switch to O, or simply lift the kettle off the stand.
GENERAL
Note: When you lift your kettle, you may see moisture on the stand. This is normal and is caused
by the steam used to switch your kettle off automatically.
BOIL DRY PROTECTION
If your kettle boils dry, a safety cut-out device will automatically switch it off. If this happens,
unplug your kettle and allow it to cool down until the cut-out resets itself. Allowing your kettle
to boil dry will shorten the life of the element.
CARE AND MAINTENANCE
1. Unplug the stand, and let the kettle cool before cleaning.
2. Wipe all surfaces with a clean damp cloth.
3. Keep the connectors dry.
To remove the funnel:
1. Hold the handle with one hand.
2. Open the lid and put your fingers inside the kettle (under the lid hinge).
3. Pull upwards and lift the rim and lid assembly off the kettle.
4. Lift the funnel out of the kettle.
5. Wipe the surfaces of the funnel with a clean, damp cloth. Don’t wipe the filter cartridge.
6. Replace the funnel and filter cartridge.
7. The flat area of the funnel should face the handle.
8. To replace the rim and lid assembly, fit the latch under the top of the handle then press the
front of the rim down to lock the clips into the kettle.
Loading ...
Loading ...
Loading ...