Loading ...
Loading ...
Loading ...
6
Countertop Mounting
Countertop
Retaining
bracket
Mounting screw
(provided)
NOTE: If the retaining brackets cannot be attached to the
underside of countertop, see the “Cabinet-face Mounting”
section.
Cabinet-face Mounting
(use if countertop mounting is not possible)
Mounting clip
(provided)
Cabinet face
Retaining
bracket
Screw
(provided)
8. Grasp sides of compactor drawer and place the wheels of
the drawer into the tracks. Lift at the handle so drawer will
go over drawer stops. Close the drawer. Make sure the
drawer opens and closes freely.
If the toe guard rubs against oor, see the “Adjusting the
Toe Guard” section for further instructions.
Adjusting the Toe Guard
If the toe guard rubs the oor covering, the toe guard clearance
may be changed as follows:
1. Mark on each side of the toe guard the amount of toe guard
that rubs the oor covering.
2. Remove the drawer from the compactor. (See steps 9 and
10 in the “Unpacking” section.)
3. Use a ruler and a pencil or chalk to draw a line between
the marks on each side of toe guard. Use scissors or a utility
knife to cut toe guard along line.
4. Replace drawer. If toe guard still rubs oor covering, repeat
steps 1-3.
Installing a Custom Panel
Dimensions
Use these dimensions to create a custom panel. The panel
should be 3/4" (1.9 cm) thick.
29
3
/
8
" max
(74.6 cm)
15" max
(38.1 cm)
Installation
1. Align the bottom of the custom panel with the bottom of
the exterior drawer front and rest the panel on the rest tab.
NOTE: The bottom of the custom panel should not extend
below the bottom rest tab which is located at the lower
center of the exterior drawer front.
Rest tab
Loading ...
Loading ...
Loading ...