Loading ...
Loading ...
Loading ...
20
Start the wash programme
1. Check that when the dishes and cutlery are
loaded in the dishwasher the spray arms are free
to rotate.
2. Open the tap fully.
3. Shut the door.
4. Press the On/Off button. The On/Off button indica-
tor lights up.
5. Press the programme button for the required pro-
gramme (see “Programme Table”). The pro-
gramme indicator lights up. One or two lights will
flash in the multidisplay. During this time it is pos-
sible to reselect the programme. The selected
wash programme will start after about 6 seconds.
The current wash programme stage will always be
shown in the multidisplay.
3
If the top light and/or the middle light in the
multidisplay flash after the programme has
started please read the section “What to do
if...”.
Interrupting or ending the wash
programme
3
Only interrupt a wash programme that is run-
ning if it is absolutely necessary. After the
appliance has been closed again the air that
has entered will be greatly heated and
expand. As a result water may penetrate the
base of the appliance and trigger the anti-
flood system.
Interrupt the wash programme by open-
ing the door.
1
Hot steam can escape from the appliance
when the door is opened. (deleted by the
reviewer) Open the door carefully.
1. Open the door of the dishwasher. The wash pro-
gramme will stop.
2. Lights are flashing in the multidisplay.
3. Shut the door. The wash programme continues.
Ending the wash programme
1. Press the button for the wash programme that is
running and hold it down until the programme indi-
cator for the wash programme goes out.
2. Release the programme button; the wash pro-
gramme has been ended.
Pause function
3
The pause function can only be initiated
before the drying section of the programme.
If the pause function is initiated during the
drying section of the programme the wash
programme is ended.
Using the pause function the dishwasher can be tem-
porarily stopped.
1. Press the On/Off button. The wash programme
will stop.
2. All indicators will go out.
3. When after a short time the wash programme is to
continue, press the On/Off button again. The wash
programme will continue.
2
The wash programme should not be stopped
for a prolonged period or the cooled water
will need to be reheated resulting in
increased energy consumption.
Load Sensing
If a wash programme is started even though there are
only a few dishes in the upper and/or lower basket, an
intelligent electronic system adjusts the amount of
water and the duration of the wash programme to the
number of dishes. By this means it is possible to
wash only a few dishes quickly and economically. At
half load (6 place settings), up to 2 litres of water and
0.2 kWh of electricity are saved.
Switching Off the Dish-
washer
Switch off the dishwasher when w is illuminated on
the programme progress display.
1. Press the ON/OFF button
M. The ON/OFF but-
ton
M indicator extinguishes.
1
Hot steam may escape from the appliance
when opening the door immediately after the
end of the programme. Therefore:
2. Open the door carefully.
Emptying the Dishwasher
3
• Hot dishes are sensitive to knocks. The dishes
should therefore be allowed to cool down before
removing them from the appliance.
• Leave the dishes in the dishwasher for approx.
15 minutes after the end of the programme so that
they dry better and can cool down.
• First empty the lower basket, and then the upper
rack. By using this procedure you will avoid any
water that may be remaining in the upper basket,
dripping onto the dishes in the lower basket and
leaving water marks.
Loading ...
Loading ...
Loading ...