Loading ...
Loading ...
Loading ...
Programming SABRE SB35 to Respond to Your TV Remote
13
SB35
Subwoofer Phase Adjustment (0-180°)
This switch determines whether the subwoofer’s piston-like action moves in and out
in phase with the speakers in the soundbar. If the subwoofer were to play out of phase
with the soundbar speakers, some of the sound waves produced by the soundbar and
subwoofer could be canceled out at some frequencies, reducing the bass performance
and sonic impact. This phenomenon depends on the relative placement of all the
speakers in the room up to some extent.
Programming SABRE SB35 to Respond to Your TV
Remote
You can program the SABRE SB35 to make it respond to your TV remote’s power, mute,
volume up and volume down commands. This programming lets you control your
whole system with your TV remote. Before beginning to program the SABRE SB35, have
your TV remote in hand. We recommend sitting down in front of the soundbar.
NOTE: Some steps will time out, so read through this entire procedure
before you begin.
Have the TV remote in hand. When you start programming the remote, be ready to
aim the TV remote control in front of the soundbar from about 300 mm – 900 mm
(about 12 – 36 inches) away.
To program the Power, Volume and Mute command:
1. Ensure that the SABRE SB35 is switched ON.
2. On the soundbar, press and hold the Surround button until the
display on the SABRE SB35 indicate you are in learning mode.
To program the Power command:
• Press the Power button on the soundbar and press the power button on the
TV remote control.
To program the Volume command:
• Press the Volume + button on the soundbar and press the Volume + button
on the TV remote control.
• Press the Volume – button on the soundbar and press the Volume – button
on the TV remote control.
To program the Mute command:
• Press the Volume + and Volume – button on the soundbar and then press
the Mute button on the TV remote.
NOTE: If you would like to program a new TV remote control or you are
missing a command, restart the whole process.
If you would like to cancel the learning, reset the SB35. Put the SB35 in Standby mode,
press and hold the Surround and Volume – button simultaneously. Once factory
defaults are restored, the SB35 surround button will flash white for one second, then
the unit will enter into operational mode.
Resetting Factory Default Settings
If you want to restore all the settings to factory default setting, press Surround and
Volume – keys in standby mode.
The factory default setting values are shown in the table below.
Item Value
Source Optical
System Volume -20dB
Surround Mode Stereo
WAVE Medium
Harman Volume Low
Loading ...
Loading ...
Loading ...