Loading ...
Loading ...
Loading ...
EN-13
Prior to using the machine for the rst time
• Check whether the electricity and supply water specications match the values indicated by the installation
instructions for the machine.
• Remove all packaging materials inside the machine.
• Set the water softener.
• Add 1 kg salt into the salt compartment and ll with water up to a level at which it will almost overow.
• Fill the rinse aid compartment.
PREPARING THE MACHINE FOR USE
The importance of water decalcication
For a good washing function, the dishwasher needs soft, i.e. less calcareous water. Otherwise, white lime
residues will remain on the dishes and the interior. This will negatively affect your machine’s
washing, drying and shining performance. For this reason, a softener system is used on dishwashers. The
softener system has to be refreshed so that it operates with the same performance also during the next wash.
For this purpose, dishwasher salt is used.
Filling with salt
Use softener salt specically produced for use in
dishwashers. To put softener salt, rst remove the
lower basket and then open the salt compartment
cap by turning it counter clockwise.1 2 At rst use
ll the compartment with 1 kg salt and water3 at
overowing level If available, using the funnel
4provided will make lling easier. Ret the cap and
close it After every 20th-30th wash, add salt into
your machine until it lls up (approx. 1 kg) Fill
the salt compartment with water at rst use only.
We recommend to use small grained or powder
softener salt. Do not put table salt into your
machine. Otherwise, the function of the softener the
compartment may decrease over time. When you
start the machine, the salt compartment gets lled
with water. Therefore, add the softener salt in prior
to starting your machine. This way, overowing
salt gets immediately cleaned up through the
wash operation. If you will not wash any dishes
immediately after adding salt, then run a short
washing program with an empty machine in order
to avoid corrosion on your machine due to the salt
overow while lling the salt container. In order
to understand whether or not the amount of
softener salt in the machine is sufcient, check the transparent section on the salt compartment cap. There is
sufcient salt if the transparent section is green. Salt has to be added if it is not green.
Testing strip
The washing effectiveness of your machine depends on the softness of the tap water. For this reason,
your machine is equipped with a system that reduces the hardness in mains water supply. The
washing effectiveness will increase when the system is correctly set. To nd out the water hardness
level of water in your area, contact your local water board or determine water hardness level by using
the test strip(if available).
Open
the
testing
strip
Run
water
through
your
tap for
1 min.
Keep
the
testing
strip in
water
for
1.sec.
Shake the
testing strip
after taking
it out of
water
Water
for 1
min.
Make your machine’s water hardness setting
according to the result obtained through the testing
strip.
Level 1 No Lime
Level 2 Very low
lime content
Level 3 Low
lime content
Level 4 Medium
lime content
Level 5 Lime content
Level 6 High
lime content
CHAPTER -4: PREPARING THE MACHINE FOR USE
Loading ...
Loading ...
Loading ...