Loading ...
Loading ...
Loading ...
8
OPERATING INSTRUCTIONS
Energy Saver Function
The Energy Saver Function will automatically cycle
the fan on and off when the compressor is not in use
to minimize how often the compressor needs to turn
on. This function is available in Cool, Dry, and Auto
modes.
The fan will continue to run for 3 minutes after the
compressor turns off. The fan will then cycle on for
2 minutes in 10 minute intervals until the ambient
temperature is above the set temperature, at which
point the compressor will turn on and cooling will
resume.
Sleep Function
The Sleep Function can be used to conserve
energy during sleeping hours. When selected,
the set temperature will increase by 2° per hour
for two hours. The appliance will hold the new
set temperature for 6 hours before automatically
returning to normal operation.
The Sleep Function can be canceled at any time by
pressing the Sleep Button.
Follow Me Function
There is a temperature sensor built into the remote
control that will continuously collect the current
room temperature. Keep the remote control with
you and the appliance will automatically adjust the
set temperature based on the current temperature
where you are located.
Press the Follow Me button on the remote control
to activate the Follow Me function. The remote will
display the current temperature at its location. The
remote will send a signal to the air conditioner
every 3 minutes, so long as you remain within
range of the appliance.
The maximum distance for the Follow Me feature is
8 meters (26 feet). This feature is available in Cool
and Auto modes.
AIR FILTER
The air fi lter should be cleaned approximately every
2 weeks. The air fi lter may require more frequent
cleaning if there is signifi cant dander or fur in the
air.
1. The air fi lter is located behind the front intake
grill. Grasp the fi lter by the center and pull up
and out.
2. Use a vacuum cleaner with a soft brush
attachment to remove any large debris or dust
build up from the air fi lter.
3. Wash the fi lter in lukewarm, soapy water, below
40°C (104°F), or use a neutral cleaning agent.
4. Rinse the fi lter with clean water and dry
thoroughly before reinstalling in the appliance.
5. Press the fi lter button on the control panel to
resume normal functioning.
Note: Do not operate the appliance without the air
fi lter installed.
CLEANING
To avoid possible electric shock, ensure that the
appliance is unplugged before performing any
cleaning or maintenance.
The outside of the appliance can be wiped clean
with a soft cloth or with a lukewarm, damp cloth if
necessary.
Do not use gasoline, benzene, thinner or any
other chemicals to clean this appliance as these
substances can cause damage to the fi nish and
deformation of plastic parts.
Never pour water directly onto the appliance as this
will cause deterioration of electrical components
and wiring insulation.
CARE & MAINTENANCE
Loading ...
Loading ...
Loading ...